January 5, 2006 - On January 5, 2006, the Illinois Pollution Control Board sent to second-notice the rulemaking proposal docketed as In the Matter of: Proposed Amendments to Exemptions From State Permitting Requirements for Plastic Injection Molding Operations (35 Ill. Adm. Code 201.146) (R05-20). The proposal by the Chemical Industry Council of Illinois (CICI) would add plastic injection molding operations to the existing list of 59 permit exemptions in Section 201.146. CICI asserts the purpose of this rulemaking is to reduce the burden of state air permitting of low emitting units and activities for the Illinois Environmental Protection Agency (IEPA) as well as owners and operators of plastic injection molding processes.
Board Sends To Second-Notice A Proposed Rulemaking to Revise the Board’s
Regulations For Air Construction And Operating PermitsOn January 5, 2006, the Illinois Pollution Control Board sent to second-notice therulemaking proposal docketed as In the Matter of: Proposed Amendments to ExemptionsFrom State Permitting Requirements for Plastic Injection Molding Operations (35 Ill.
Two hearings have been held in this matter.
The first hearing was July 2, 2005, in
Chicago.
The proposal is
substantively unchanged from that adopted by the Board in September 2005.
Hard copies may be obtained for $.75 per page from the Clerk’s
office at 312-814-3629, or by writing to the Clerk’s office....
Allowed
Adobe Portable Document Format (.pdf) - application/pdf
Publications 
