May 5, 2005 - On May 5, 2005, the Illinois Pollution Control Board accepted for hearing the rulemaking proposal docketed as In the Matter of: Proposed Amendments to Exemptions From State Permitting Requirements for Plastic Injection Molding Operations (35 Ill. Adm. Code 201.146) (R05-20). The proposal by the Chemical Industry Council of Illinois (CICI) would add one category to the existing list of 59 permit exemptions in Section 201.146. CICI asserts the purpose of this rulemaking is to reduce the burden of state air permitting of low emitting units and activities. According to CICI, the proposed amendments will benefit both the Illinois Environmental Protection Agency (IEPA) and owners and operators of plastic injection molding processes.
Board Considers A Proposed Rulemaking to Revise the Board’s Regulations For
Air Construction And Operating PermitsOn May 5, 2005, the Illinois Pollution Control Board accepted for hearing the rulemakingproposal docketed as In the Matter of: Proposed Amendments to Exemptions From StatePermitting Requirements for Plastic Injection Molding Operations (35 Ill.
CICI asserts the purpose of this rulemaking is to reduce the burden of state air permitting
of low emitting units and activities.
The proposed amendment would include plastic injection molding operations in the
categories of emissions units exempt from state air permitting requirements.
CICI
contends that because of the low l...
Allowed
Adobe Portable Document Format (.pdf) - application/pdf
Publications 
