ILLINOIS POLLUTION CONTROL BOARD
July 11, 1986
IN THE MATTER OF:
)
NEW SOURCE PERFORMANCE STANDARDS:
)
METAL COIL SURFACE COATING
)
R86-26
(35 ILL.
ADM. CODE 230.560)
)
RESOLUTION AND ORDER OF THE BOARD
(by J. Theodore Meyer):
This matter comes before the Board upon a June 24, 1986
notice
(51 Fed.
Reg.
22938) published by the United States
Environmental Protection Agency (USEPA) of the promulgation of an
amendment to the National Standards
of Performance for New
Stationary Sources (NSPS):
Subpart TT:
Standards of Performance
for
New Stationary Sources; Metal Coil Surface Coating
40 CFR 60
(Ill. Adm. Code 230.560)
Pursuant
to Section 9.1
of the Environmental Protection Act,
the Board
is required
to adopt amendments
“in substance
identical”
to the federal NSPS amendments.
The Board will do so
through incorporation by reference of the federal amendment as
a
peremptory amendment.
The Board will also update the CFR
reference to the 1985 edition.
ORDER
The Board hereby adopts
the following amendments to Title
35:
Environmental Protection Subtitle
B:
Air Pollution; Chapter
I:
Pollution Control Board; Part 230:
New Source Performance
Standards:
SUBPART TT:
METAL COIL SURFACE COATING
Section 230.560
Metal Coil Surface Coating Operations
The Board incorporates by reference
40 CFR 60, Subpart TT
(19825),
as amended at 47
Fed.
Reg. 49606, November
1,
1982;
as
amended
in R86—26
at
51 Fed. Rev.
22938, June 24,
1986.
IT
IS SO ORDERED.
71-378
—2—
I, Dorothy
M. Gunn, Clerk of the Illinois Pollution Control
Board,
hereby certify that the above Resolution and Order was
adopteç3 on the
//7~~
day of
-v
,
1986 by a vote
of
___
C
.
—
rThrothy ~4.Gux~(,Clerk
Illinois Pollution Control Board
71-379